MIL-G-26869D
3.2.5 Safety and health requirements. All parts, components, mechanisms,
and assembl ies furnished on th e machine, whether or not specifically required
herein, shall conform with all requirements of 29 CFR 1910 and ANSI B11.7. If
a conflict arises between 29 CFR 1910 and B11.7, 29 CFR 1910 shall apply.
Additional safety and health requirements shall be as specified in detail (see
6.2). Covers, guards, or other safety devices normally furnished as standard
on the manufacturer's commercial machine supplied to the commercial market
shall be provided for the point of operation and all other parts of the
machine that present safety hazards. Additional guarding dependent on
workpiece size and configuration shall be provided when specified and fully
described by the procuring activity (see 6.2).
shall not contain mercury or
3.2.6 Mercury restriction. The machine
mercury compounds nor be exposed to free mercury during manufacture.
3.2.7 Asbestos restriction. Asbestos and materials containing asbestos
shall not be used on or in th e machine.
3.2.8 Environmental protection. During
the
manufacture,
operation,
service, transportation, or storage of the machine, and its components,
materials hazardous to the ecological system as prohibited by Federal, state,
or local statutes in effect at the point of installation on the date of the
contract shall not be used or emitted.
3.2.9 Lubrication. Means shall be provided to ensure lubrication for all
moving parts. Recirculating lubrication systems shall include a cleanable or
replaceable filter. Each lubricant reservoir shall have means for determining
fluid level. All oil holes, grease fittings, and filler caps shall be
accessible.
3.2.10 Interchangeability. To provide for replacement of worn parts, all
parts shall be manufactured to definite dimensions and tolerances that will
permit installation of replacement parts without modification of the part or
machine.
3.3 Construction. The machine shall be constructed of parts which are
new, without defects, and free of repairs. The structure shall withstand all
forces encountered during operation of the machine to its maximum rating and
capacity without permanent distortion.
3.3.1 Castings and forgings. All castings and forgings shall be free of
defects, scale, and mismatching.
No processes such as welding, peening,
plugging, or filling with solder or paste shall be used for reclaiming any
defective part. Such processes may be used only for enhancing surface finish
and appearance.
3.3.2 Fastening devices. All fasteners shall be installed to prevent
change of tightness. Fastening devices subject to removal or adjustment shall
not be permanently installed.
3.3.3 Surfaces, All surfaces shall be clean and free of harmful or
All edges shall be either rounded or beveled unless
extraneous materials.
sharpness is required to perform a necessary function.
Except as otherwise
4
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business