MIL-S-45860D
specific point-of-operation guarding is required, the procuring activity
should specify the exact configuration of the guard required because the guard
configuration is dependent on the size and configuration of the workplaces.
Additional safety and health requirements shall be as specified (see 6.2.1).
3.2.6 Mercury restriction. The machine shall not contain mercury or mer-
cury compounds nor be exposed to free mercury during manufacture.
3.2.7 Asbestos restriction. Asbestos and materials containing asbestos
shall not be used on or in the machine.
3.2.8 Environmental protection. The machine shall be so designed and con-
structed that, under the operating, service, transportation, and storage
conditions described herein, the machine shall not emit materials hazardous to
the ecological system as prohibited by Federal, state, or local statutes in
effect at the point of installation.
3.2.9 Lubrication. Means shall be provided to ensure adequate lubrication
for all moving parts Recirculating lubrication systems shall include a
cleanable or replaceable filter. Each lubricant reservoir shall have means
for determining fluid level. All oil holes, grease fittings, and filler caps
shall be accessible.
3.2.10 Interchangeability. All parts shall be manufactured to definite di-
mensions and tolerances that will permit installation of replacement parts
without modification of the part or machine.
3.3 Construction. The machine shall be constructed of parts which are new,
without defects, and free of repairs. The structure shall withstand all
forces encountered during operation of the machine to its maximum rating and
capacity without permanent distortion.
3.3.1 Castings and forgings. All castings and forgings shall be free from
Processes such as welding, peening, plug-
defects, scale, and mismatching.
ging, or filling with solders or pastes shall not be used on castings or
forgings to reclaim any defective components for use on the machine. Such
processes may be used only for enhancing surface finish and appearance.
Welding, brazing, or soldering shall
3.3.2 Welding, brazing, or soldering.
be employed only where specified in the original design. None of these pro-
cesses shall be employed as a repair measure for any defective part.
3.3.3 Fastening devices. All fasteners shall be installed to prevent
change of tightness. Fastening devices subject to removal or adjustment shall
not be permanently installed.
3.3.4 Surfaces. All surfaces shall be clean and free of harmful or extra-
neous materials. All edges shall be either rounded or beveled unless sharpness
is required to perform a necessary function. Except as otherwise specified
herein, the condition and finish of all surfaces shall be in accordance with
the manufacturer's commercial practice.
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business