MIL-S-45860D
3.4.10 Hour meter. Unless otherwise specified (see 6.2.1) type II, III,
and IV machines shall be equipped with an hour meter. The hour meter shall be
installed to display accumulated operating time of the main drive motor.
The meter shall be of the nonsetting type and shall have a range of O to
99,999 hours in increments of not greater than one hour. The meter shall be
sealed to prevent the entrance of dust and moisture and shall be mounted to
withstand shock and vibration generated by the machine. Upon reaching 99,999
hours, the meter readout shall automatically return to zero and continue to
accumulate time.
3.5 Size and capacity. Unless otherwise specified (see 6.2.1), the size
and capacity of the machine shall be not less than those specified in tables
I, II, III, and IV for the machine size specified.
3.6 Performance. The machine shall be capable of shrinking or stretching
metal sheets, angles, flat bars, and plates by increasing or decreasing the
length of the metal in a localized area. The machine shall have the ability
to remove wrinkles and produce double curvatures from flat sheets. All op-
erations shall be performed within the capacities of tables I, II, III, and
IV.
3.6.1 Additional performance requirements. Performance features required
in addition to, or in lieu of, the requirements herein shall be as specified
and fully described (see 6.2.1).
furnished
the
3.7 Standard equipment. All equipment
normally
with
manufacturer's standard commercial machine
shall be furnished, including the
following:
a.
One set of maintenance and adjusting tools.
b.
One pair of standard stretching jaw assemblies.
c.
One pair of extended shrinking jaw assemblies.
d.
One pair of extended stretching jaw assemblies.
3.8 Optional equipment. Optional equipment shall be furnished as specified
and shall be fully described (see 6.2.1).
Repair parts
shall be furnished as specified (see
3.9 Repair parts.
6.2.1).
3.10 Marking on plates and charts. All words on plates and charts shall be
in the English language. Characters shall be engraved, etched, embossed, or
stamped in boldface on a contrasting background.
3.10.1 Lubrication plate. A corrosion resistant lubrication plate shall
be securely attached to each machine. The plate shall contain the following
information:
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business